Once this has completed, run the inventory again from the SPP and the warning should now be gone and the firmware and driver updates should now apply.

I chose AutoDeploy, to set the mode use the below command. After the reboot the next step is to set the iSUT mode there are 4 To install use esxcli command, this is the command I used.Įsxcli software vib install -d /hpe_sut/sut-esxi6.0-bundle-2.3.6.0-16.zip Once the install has completed, a restart is required to finish the install. When I look at the Custom ISOs tab for vSphere downloads, I can of course switch between vSphere versions, (7.0, 6.7, etc), and within the list of available custom ISOs for ESXi install, there will be separate entries for Update release, e.g. Once the files are copied over, use either SSH or ESXi Shell to install the tools. I created a folder called hpe_isut on the ESXi host to copy the file to. Once download and extracted we need to copy the file to the ESXi host, the easiest way to copy is by enabling SSH on the host and using WinSCP. Below is the link to version 2.3.6 which was the version I used. If iSUT is not installed the update will be staged on the host but wont install. To install, download iSUT from the HPE Support site. The issue is due to HPE changing from installing updates directly to the ESXi OS level and instead using HPE ILO. We have two HP Proliant D元80 G7 Servers and one HP Proliant DL580 G5 Servers and we have installed VMWare 6.5.0 Build 4564106 on all of them.

I was installing some new ESXi host using HPE Gen 10 blade servers and was getting a warning when trying to update the firmware using HPE SPP (Service pack for proliant). But we have to update VMWare ESXi on these Servers to the latest supported version.

Hpe vmware esxi 6.7 download